Seven Lakes SC maps
#1
Posted 31 December 2007 - 12:52 AM
#2
Posted 31 December 2007 - 07:46 AM
#3
Posted 31 December 2007 - 05:19 PM
smallengineguy, on Dec 31 2007, 07:46 AM, said:
#4
Posted 31 December 2007 - 06:56 PM
#7
Posted 02 January 2008 - 09:22 PM
#8
Posted 03 January 2008 - 06:22 AM
artic6, on Jan 2 2008, 09:22 PM, said:
Yes you can, only problem is the lakes. Don't know how safe they are right now. If you can go down Corr 19 from OVSC system to 7 lakes system. The trail changes to corr 22 on the south side of Pine River Pond, that brings you to rail bed, corr 26. Take that right on the bed to Wolfboro. Take Wolfboro system to Castle In the Clouds, go over the back side of the mountain and that will bring you back to OVSC system. If you go to one of the places mentioned above, they should have the new maps.
#9
Posted 03 January 2008 - 07:20 AM
#10
Posted 07 January 2008 - 06:34 AM
smallengineguy, on Jan 3 2008, 07:20 AM, said:
Ya, I know, we are dealing with them on sharing a short section fron Jones gate to our new reroute. On getting to the Castle, I could show you, have no Idea what the trail numbers are though. You need to get to Mirror lake and head North East up through the Power lines over Transformer hill up to the Castle. On another note, was out grooming Sat night behind Moose Mountain, we put up our new trail map at Jones gate, where you have your map. Went back Sun morning on personal sled and your map and plexiglass was torn down. Map was gone, plexiglass was tossed behind the kiosk.
#11
Posted 07 January 2008 - 07:20 AM
#12
Posted 07 January 2008 - 09:41 AM
CATMAN, on Jan 7 2008, 06:34 AM, said:
#15
Posted 07 January 2008 - 10:00 AM
#16
Posted 07 January 2008 - 12:29 PM
steviep, on Jan 7 2008, 10:00 AM, said:
Ours are 20'' by 30'', roughly, not sure who printed it. I will find out and let you know. The same with the cost. I believe they are roughly $4 a piece, cuz the stores are selling them for $6
#17
Posted 07 January 2008 - 07:40 PM
#18
Posted 07 January 2008 - 09:02 PM
smallengineguy, on Jan 7 2008, 07:40 PM, said:
#19
Posted 08 January 2008 - 07:04 AM
Reply to this topic
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users













